- Provides effective chlorine taste & odor reduction (Based on manufacturer's internal testing.)
- BB cartridges are ideal for point-of-entry (POE) and other high flow rate applications
- Unique design reduces carbon fines in filtered water
- Available in a wide variety of sizes
Unit of Measure
Specifications
Brands |
N/A Culligan® Pentair Pentek® |
Maximum Dimensions |
N/A 4-1/2 x 20 in114 x 508 mm |
Initial Pressure (ΔP) at 4 Gallons Per Minute (gpm) Flow Rate |
N/A 0.90 psi |
Initial Pressure (ΔP) at 15.1 Liter Per Minute (L/min) Flow Rate |
N/A 0.06 bar |
Chlorine Taste and Odor Reduction at 4 Gallons Per Minute (gpm) Flow Rate |
N/A > 70000 gal |
Chlorine Taste and Odor Reduction at 15.1 Liter Per Minute (L/min) Flow Rate |
N/A 265000 L |
Industry Standards/Certifications |
N/A
The TSGAC-10 is Tested and Certified by NSF® International to NSF®/ANSI Standard 42 for material requirements only. International Organization for Standardization (ISO-9001) Registered |
Materials of Construction
Filter Media |
N/A Granular Activated Carbon |
Outer Shell Material |
N/A Polyethylene |
End Cap Material |
N/A Polypropylene |
Gasket Material |
N/A Buna-N |
Inner Wraps/Core Material |
N/A Polypropylene |
Temperature |
N/A 40 to 125 ºF4.4 to 51.7 ºC |
Additional Information
Additional Information |
N/A
Sandwiched between the outer shell and the core is a bed of granular activated carbon (GAC). The unique radial flow design offers the benefits of granular activated carbon (GAC) filtration, such as low pressure drop, while at the same time significantly reducing the release of carbon fines commonly associated with GAC style cartridges. RFC Series cartridges are available in a wide variety of sizes and are ideal point-of-entry (POE) and other high flow rate applications. |
Note
Note |
N/A
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. The granular activated carbon cartridges will contain a very small amount of carbon fines (very fine black powder). After installation, a new cartridge should be flushed with sufficient water to remove all traces of the fines from your water system before using the water. Each time you use your filtered water tap for drinking or cooking purposes it is recommended that you run (flush) the tap for at least 20 seconds prior to using water. This is particularly important if the water tap has not been used daily. |